Updates: Armies on Parade and Antares

It’s been a little while – over a month, now – since I posted. A lot of real life stuff, including a new house and moving into said house, has meant almost zero hobby time until this past week. But now that things have settled down, I’m getting back into the swing of things. So, here are a couple updates.

First up is an Armies on Parade board. After missing the last couple of Armies on Parade events, I promised my local Games Workshop shop manager I’d participate. Knowing I wouldn’t have time for something amazing with the board, and it being a little while since I did something like this, I decided to go the simple route. I wanted to do a two-tier board to keep it from being completely boring. The three options I though about were a centralized tier, an unbroken back tier, or a split back tier. As you can see, I went with the third option.

Armies on Parade board, foam

The Armies on Parade rules say the board limit size is 24″ x 24″ with no real height limit. Height wasn’t really my concern this time around. I did go for the full size limit on the board because I was concerned about running out of space. I picked up two 2′ x 2′ squares of insulation foam and a thin plywood 2′ x 2′ board from my local Home Depot, along with a 2″ brush and big bottle of wood glue. I glued the base foam square to the wood board. I figured the would would act to reinforce the foam for transport, as well as protect it in case of any accidental drops. Once that was dry, I marked off where I wanted the tier pieces to go, then I use a hot wire foam cutter to carve appropriate chunks out of the other piece of foam. I smoothed out the foam surfaces where the cuts were made and then glued the pieces down.

Continue reading “Updates: Armies on Parade and Antares”